CLEAN OUTPUT SHAFT SEAL AND HOUSI ASSEMBLYNG

TM 1-2840-252-23-2

2-40

CLEAN OUTPUT SHAFT SEAL AND HOUSI ASSEMBLY

2-40

INITIAL SETUP

Equipment Condition:

Off Engine Task

Output Shaft Seal and Housing Assembly Re-

Applicable Configurations:

All

moved (Task 2-39)

Tools:

General Safety Instructions

Powerplant Mechanic's Tool Kit,

WARNING

NSN 5180-00-323-4944

Goggles

Dry cleaning solvent (E19) is flammable

Dry, Compressed Air Source

and toxic It can irritate skin and cause

Material:

burns. Use only in well-ventilated area,

Dry Cleaning Solvent (E19)

away from heat and open flame. In case

Gloves (E24)

of contact, immediately flush skin or

Lint-Free Cloth (30)

eyes with water for at least 5 minutes

Personnel Required:

Get medical attention for eyes

Aircraft Powerplant Repairer

1. Wear gloves (E24) Immerse output shaft seal

housing assembly (1) in dry cleaning solvent (E19)

and agitate. Use brush on inside surfaces (2)

2. Wipe dry. Use clean, dry, lint-free cloth (E30)

WARNING

When using compressed air for cleaning,

use approved protective equipment for

eyes and face. Do not use more than 30

psig air pressure. Do not direct air

toward yourself or another person.

Failure to comply could result in injury

to eyes or skin. In case of injury, get

medical attention.

3. Wear goggles Blow dry inside surfaces (2) using

clean, dry, compressed air

FOLLOW-ON MAINTENANCE

Inspect Output Shaft Seal and Housing Assembly

(Task 2-41)

END OF TASK

2-328