CALIBRATION PROCEDURE FOR SIGNAL GENERATOR SG-1207/U (HEWLETT-PACKARD, MODEL 8642M)

*TB 9-6625-2182-35

DEPARTMENT OF THE ARMY TECHNICAL BULLETIN

CALIBRATION PROCEDURE FOR

SIGNAL GENERATOR SG-1207/U

(HEWLETT-PACKARD, MODEL 8642M)

Headquarters, Department of the Army, Washington, DC

26 November 2004

Distribution Statement A: Approved for public release; distribution is unlimited.

REPORTING OF ERRORS AND RECOMMENDING IMPROVEMENTS

You can improve this manual. If you find any mistakes or if you know of a way to

improve these procedures, please let us know. Mail your letter or DA Form 2028

(Recommended Changes to Publications and Blank Forms) directly to: Commander,

US Army Aviation and Missile Command, AMSAM-MMC-MA-NP, Redstone Arsenal,

AL 35898-5000. A reply will be furnished to you. You may also provide DA Form

2028 information to AMCOM via e-mail, fax, or the World Wide Web. Our fax

number is DSN 788-6546 or Commercial 256-842-6546. Our e-mail address is

2028@redstone.army.mil. Instructions for sending an electronic 2028 may be found

at the back of this manual.

For the World Wide Web, use

https://amcom2028.redstone.army.mil.

Paragraph

Page

SECTION

IDENTIFICATION AND DESCRIPTION

Test instrument identification...........................

Forms, records, and reports ...............................

Calibration description ......................................

II.

EQUIPMENT REQUIREMENTS

Equipment required ...........................................

Accessories required ...........................................

III.

CALIBRATION PROCESS

Preliminary instructions....................................

Equipment setup ................................................

Line stability.......................................................

Frequency accuracy ............................................

RF output ............................................................

Output level flatness.....................................

Attenuation .........................................................

Spectral purity ....................................................

Pulse modulation ................................................

Amplitude modulation .......................................

Frequency modulation........................................

Phase modulation ...............................................

Internal oscillator ...............................................

Power supply.......................................................

Final procedure...................................................

_________

*This bulletin supersedes TB9-6625-2182-35, dated 29 October 2001, including all changes.