|
| |
TM 10-4930-246-13&P
4-7.
INLETELBOWREPLACEMENT. - continued
NOTE
To preventlossof ballsandaidassembly,placea suitablecontainerunderbody
opening. Catch all balls as they fall from opening.
(3) Hold the fuel nozzle body (3) with bolt hole vertical (pointed down) and allow all balls (4) to be removed
through the bolt hole. Rotation between the body and the inlet elbow (5) will be required to allow the balls
to fall out of the hole.
(4) Slip the inlet elbow (5) out of the fuel nozzle body (3).
(5) Remove O-ring (6), seal (7), and O-ring (8) from elbow (5) and discard.
b.
Installation See figure 4-4.
(1) Lubricate and install new 0-rings (6) and (8), in the groove in elbow (5) and fuel nozzle body (3), lubricate
and install new seat (7) onto inlet elbow (5) on top of 0-ring.
(2) Insert elbow (5) into fuel nozzle body (3) so that bearing race alines with screw hole in body.
NOTE
Do not use any form of grease on screw, O-ring or balls.
(3) Install all thirty-nine ball bearings (4) through screw hole in body (3).
(4) Place new 0-ring (2) on the end of screw (1) and install screw.
(5) Install camlock disconnect assembly per paragraph 4-6.
4-8
|
