|
| |
TM 10-4320-348-14
SECTION III. TOOL AND TEST EQUIPMENT REQUIREMENTS
Refer-
Maintenance
National/NATO
Tool
ence
Category
Nomenclature
Stock Number
Number
Code
1
O, F, H
Took Kit, General
5180-00-699-5273
Mechanics
2
O
Shop Equipment, Automotive Maintenance and
4910-00-754-0654
Repair: Unit Maintenance, Common No. 1
3
F, H
Shop Equipment, Automotive Maintenance
4910-00-754-0705
and Repair: Field Maintenance, Basic
4
O
Riveter, Blind, Hand
5120-00-017-2849
SPECIAL TOOLS
5
O
Bolt, Hex Head
3/8-16 x 4.00 inches long.
SECTION IV. REMARKS
REFERENCE
REMARKS
CODE
A
Repair is limited to replacement of defective parts.
B
Repair of nozzle assembly is limited to replacement of defective couplings.
C
Repair by replacing defective rivets, latches, handles, and hinge.
D
Repair by replacing defective rivets, latch door hinge, plastic foam insulation, and tie-down straps.
E
Lubrication system consists of maintenance to the lubrication pump and oil strainer only. Clean
oil strainer.
F
Repair by replacing defective exhaust silencer and spark arrestor.
G
Repair is limited to replacing defective fuel injector, fuel injector pump, fuel tank, fuel valves, and
fuel lines.
H
Repair is limited to replacement of defective starter rope. Recoil starter shall be replaced as a
unit if found defective.
I
Repair is limited to replacement of defective external speed control components only. Governor
mechanism shall not be repaired.
J
Engine repair is limited to only those components/assemblies identified on this MAC. If it is
determined that any components inside the engine crankcase are defective, the engine shall be
replaced as a unit.
K
Repair is limited to replacement of defective Y connectors, coupling halves, and ground rod.
B-7/(B-8 Blank)
|
