WELDING

TM 10-7360-209-13&P

RIVET REPLACEMENT (Continued)

5-3.

( b ) Place drill in center-punched mark. When using a power

d r i l l , rotate the bit a few turns by hand before starting motor. While drilling,

always hold drill at a 90-degree angle to work.

( c ) Avoid excessive pressure; let the drill do the cutting.

N e v e r push drill through stock. Remove all burrs with a metal countersink or

file.

( d ) Transfer holes from a drilled part to another part by placing

second part over first and using established holes as a guide.

5-4. WELDING. KCLFF major components, such as the Heater Tank Assembly, Cooking

Pot Cradle Assembly, and Table Assembly may require repair by welding. Refer

to TM 9-237 for information on welding theory and application.

5-3/(5-4 Blank)