UNPACKING THE MKT COMPONENTS (Cont)

TM 10-7360-206-13

0005 00

WARNING

INJURY CAUTION

Before raising roof jack, be sure to move pawl to latch position.

WARNING

INJURY CAUTION

Before raising roof assembly, ensure jack handle does not swing free

when pawl is moved to unlatched position.

NOTE

As an alternate, the roof may be raised with a person lifting on each of

the four lifting loops on all 4 corners at the same time.

NOTE

Should the roof assembly bind while raising, stop and raise lowest corner

to match the higher corners, then continue raising.

Remove two roof jacks (1) from the storage area in the center aisle and place into position at the front and

rear of the roof in the center aisle (2). Place the pin (3) at the bottom of the jack (1) in the corresponding

hole (4) in the kitchen floor.

Place the top (5) of the roof jack (1) under the roof edge (6) with one prong of jack top on each side of roof

center beam.

With one person at each jack and one on each side of the roof, raise both ends of the roof at the same

time. The roof jacks must be cranked up at the same rate so that the roof raises uniformly.

0005 00-18