Removal

TM 10-7360-204-13&P C. Removal (1) Remove bolt (1) from burner (2), and remove burner. (2) Remove four screws (3) that attach the bottom shield (4) to the spare generator brackets. Remove bottom shield. (3) Remove two screws (5) that attach mixing chamber and shutter assembly (7) to frame. Lift assembly (7) from frame. (4) Remove nut (8), washer (9), holder (10), if equipped, and remove bushing (11) from mixing chamber (12). (5) Remove four screws (6) and (13) that attach retaining ring (14) and air shutter (15) to mixing chamber (12). Remove air shutter and retaining ring. Remove flame valve knob from valve knob holder. (6) Remove mixing chamber (12) by lifting straight up from fuel tank. Dry cleaning solvent, P-D-680 parts is potentially dangerous repeated and prolonged skin flame or excessive heat. Flash 138 degrees F (38 degrees C to d. Cleaning. (item 5, Table F-1), used to clean to personnel and property. Avoid contact. Do not use near open point of solvent is 100 degress F to 59 degrees C). (1) The burner is cleaned with a wire brush and slot cleaner (figure 2-3, item 8). Use the slot cleaner in a rocking motion to prevent possible damage to the slot, clean each slot carefully to remove all carbon or foreign matter. Wash burner with hot soapy water, rinse with clean boiling water and air dry. The bottom shield is cleaned in the same manner as the top shield. Clean the mixing chamber and air shutter assembly in cleaning solvent P-D-680 (item 5, Table F-l), and wipe dry. (2) Lubricate air shutter after cleaning. (3) Coat the burner and unpainted parts with P-10, Grade 1, Preservative Oil (item 6, Table F-l). If the mixing chamber needs painting, use aluminum paint only (item 7, Table F-1). e. Reassembly, (1) Replace mixing chamber (12). (2) Replace air shutter (15) and retaining ring (14) using screws (6) and (13). (3) Place bushing (11) in mixing chamber (12). Install holder (10), if equipped, using washer (9) and nut (8). (4) Place mixing chamber and air shutter assembly (7) into frame and replace screws (5). DO not tighten screws (5) at this time. (5) Place bottom shield (4) on spare generator brackets and tighten screws (3). (6) Replace (7) Apply a burner (2). NOTE Position the burner so that the long arm is facing toward the air shutter (front of burner). This will be directly under the generator when it is installed. light coat of antiseize compound to threads of bolt (1) and replace bolt. Overtightening bolt will cause damage to the mixing chamber. Change 7 4-11