Flour Sifter

TM 10-7360-201-10

2-8. ASSEMBLY AND PREPARATION FOR USE-Continued

(4) Flour Sifter. When a location is

selected for the sifter, proceed

as follows:

(a)

Be sure sifter is level.

(b)

Remove inverted feed hop- per

(1) from hold down box (2); tilt

hopper slightly so hopper

fastening bar (3) clears frame.

(c)

Turn feed hopper upright and

set it in place, fitting fastening

bar lock rods into holes

provided on frame. Fasten

hopper bolts (4).

(d)

Install cloth tube (5) between

hopper (1) and hold down box

(2), and fasten tube with two

clamps.

(e)

Remove eight thumbs- crews

(6) holding inverted sifter base

(8) to machine bed.

(f)

Raise sifter machine bed (7),

and turn base over; lower

machine bed into position on

base (8). Secure with eight

thumbscrews (6).

(g)

Use four stowed hook-type

stakes (9) to anchor sifter to

ground.

WARNING

Do not operate the generator set in an enclosed area unless

the exhaust gases are piped to the outside. Inhalation of

exhaust fumes will result in serious illness or death.

(5) Generator. When a location is selected for the generator, proceed as follows:

(a) Be sure generator set is level.

(b) If generator is located indoors, be sure to pipe the exhaust gas to the outside, keep room well ventilated,

and place generator where it receives a maximum of air. There must be at least 2 feet of space on all

sides of unit.

2-36