WARNING

TM 10-7360-201-10

WARNING

Fire Precautions

·Know where fire extinguishers are located and be sure they are in serviceable condition.

·Wipe any excess lubricant from around lubrication points.

·Watch all fuel lines for leaks. If leaks are present, be sure they are corrected before operating the equipment.

·Do not use gasoline to clean fuel tanks. Keep tanks clear of sparks or flames.

·Do not start generator engine heater if fuel is dripping from the overflow tube. Shut off fuel supply and have trouble

corrected.

·Dry cleaning solvent, P-D-680 used to clean parts is potentially dangerous to personnel and property. Avoid repeated

and prolonged skin contact. Do not use near open flame or excessive heat. Flash point of solvent is 100 degrees F to

138 degrees F (38 degrees C to 59 degrees C).

Explosion Precautions

·Keep doors covering pressure relief sheets open during oven operation.

* After stopping operation, turn all fuel control valves to OFF position. Close shutoff valves at fuel tanks.

·Do not allow sparks or flames near tops of batteries. Never short-circuit a battery's electrodes to determine battery

charge.

·Before lighting oven burner, preventilate oven heating system by running the blower 2 or 3 minutes to clear out gas

fumes.

·After oven burner is shut off, let the blower run several minutes after burner stops firing to clear out gas fumes.

Mechanical Precautions

·Observe precautions for use of the jog and start pushbuttons on the mixing machine.

·Do not run oven blower for long periods with oven cold; this overloads blower motor.

·Do not turn on molder during cleaning.