 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
  TM 10-7310-239-13
CHAPTER 6
REPAIR INSTRUCTIONS
6-1. General
(2) Install downdraft diverter assembly (para 4-
13).
This chapter provides repair instructions for all
6-5. Replacement of door Latches
components and assemblies which are the responsibility
of direct support maintenance personnel.
a.
Removal.
6-2. Replacement of Thermometer Guard
(1) Open oven door and remove rivets (1, fig.
a.
Removal.
(2) Remove support rods (3) from the holes in
the latches.
(1) Remove thermometer (para 4-11).
(2) Remove rivets (1, fig. 6-1) securing
b.
Installation.
thermometer guard (2) to front of oven.
(1) Place the ends of the support rods (3)
b.
Installation.
through the latch holes.
(2) Place latches (2) in position and secure with
(1) Position thermometer guard (2) on front of
new rivets (1) by referring to the proper procedure in
oven and secure with new rivets (1) b y referring to the
proper procedure in paragraph 5-6.
(2) Install thermometer (para 4-11).
6-6. Replacement of Door Hinge Brackets
6-3. Replacement of Thermometer Pocket
a.
Removal.
a.
Removal.
(1) Close oven door and remove rivets (1, fig.
(1)
Remove the thermometer, tube, and
(2) Slide hinge brackets off of door hinge rod.
coupling (para 4-11 and 4-12).
(2) Remove rivets (1, fig. 6-2) that secure
b.
Installation.
thermometer pocket (2) to the inside wall of the center
(1) Slide, serviceable hinge brackets onto door
baking compartment.
hinge rod.
(3) Lift out thermometer pocket.
(2) Place hinge brackets (2) in position and
b.
Installation
secure with new rivets (1) by referring to the proper
procedures in paragraph 5-6.
(1) Place thermometer (2) in position and install
new rivets (1) by referring to the proper procedure in
6-7. Replacement of Lift Handle Brackets
(2) Install tube, coupling, and thermometer
a.
Removal.
(1) Remove lift handles and latching pin (para
6-4. Replacement of Flue Assembly
(2) Remove rivets (1, fig. 6-6) securing rear lift
a.
Removal
handle brackets (2) to side of oven.
(3) Remove rivets (3) securing front lift handle
(1) Remove downdraft diverter assembly (para
brackets (6) and bracket plates (5) to oven. Remove
rivets (4) and sparate lift handle brackets from bracket
(2) Remove rivets (2, fig. 6-3) securing flue
plates.
assembly in top of oven.
(3) Lift out flue assembly (3).
b.
Installation.
b.
Installation
(1) Secure rear lift handle brakets (2) to side3 of
oven with new rivets (1) by referring to the proper
(1) Place flue assembly (3) in position and
procedure in paragraph 5-6.
secure with new rivets (2) by referring to the proper
procedure
in
6-1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals