LUBRICATION ORDER

NOTES:

7. WHEEL BEARINGS.

Annually remove, clean, and

1. BLOWER SHAFT BEARING. This bearing is lubricated

pack.

by oil from pillow block oil well.

2. PILLOW BLOCK. If operated more than 12 hours a

8. MASTER CYLINDER. Semiannually check fluid level.

day, or if lubricant shows excessive sludge or

Fill to 1/2 inch from top.

carbonization, drain, and thoroughly flush block every

month or oftener. Drain plug is located on left side of

block, near sheave. Refill to full mark on liquid sight

indicator.

Copy of this Lubrication Order will remain with the

equipment at all times: instructions contained herein are

3. MOTOR BEARING RECESSES. Semiannually add

mandatory

GAA grease sparingly to seal out moisture.

4. CONVEYOR CHAINS. Every 5 days lubricate when

By Order of the Secretary of the Army:

unit is in continuous use (and after operation). and

quarterly when use is less than once every 7 days.

Lubricate chains lightly with colloidal graphite.

CARL, E. VUONO

General, United States Army

5. OIL CAN POINTS. Weekly when unit is in continuous

Chief of Staff

use clean and lightly lubricate oven door shaft bearings,

conveyor drive shaft bearings, and door- locking

mechanisms with OE. Lubricate quarterly when use is less

Official:

than once every 7 days.

THOMAS F. SIKORA

6. LUBRICATE. Quarterly.

Brigadier General, United States Army

The Adjutant General

DISTRIBUTION:

To be distributed in accordance with DA form 12-25E, (Qty

rqr blk no. 4073).

P I N : 011970/000

Card 2 of 2