|
| |
Back
LINK-11 DATA TERMINAL SET (DTS) | Up
Fire Controlman Volume 06-Digital Communications | Next
Audio Tone Generation and Characteristics |
Figure 2-13.—Broadcast mode message format.
the radio set.
The key-line signals necessary to
control the transmit and receive states of the radio set
are also generated by the DTS. Data received from
the upper sideband (USB) and lower sideband (LSB)
portions of the
radio
set
receiver, in
the form of audio tones, is converted into parallel
binary data and sent to the CDS computer.
Currently several design generations of Link-11
data terminal sets are used in the fleet. These include
the AN/USQ-59 and 59A, the AN/USQ-63, and the
AN/USQ-74. Originally introduced in the early
1960s, each successive generation of the Link-11 data
terminal set reflects additional knowledge gained
from fleet use and advances in technology. Although
the technology used in the different models of the
Link-11 DTS may be vastly different, all of them
perform the same function.
Normally, the DTS operates in the half-duplex
mode, meaning it can either receive or transmit data,
but it cannot do both at the same time. An exception
is during system test when the DTS operates in full-
duplex mode and can simultaneously send and
receive data.
DATA TERMINAL SET FUNCTIONS
The DTS also performs the following functions:
Error detection and correction
Audio signal generation
Link-11 protocol and interface control
Error Detection and Correction (EDAC)
The DTS receives data from the CDS computer in
the form of 24-bit binary data words. The 24-data bits
Table 2-1.—DTS Parity Bit Status Codes
2-10
|
