ASSIGNMENT 2 Textbook  Assignment: “Radar  Systems  Equipment  Configurations,”  chapter  2,  pages  2–3 through  2–24. 2-1. Use of BIT circuitry in the AN/SPS–67(V)  radar  will  have  which of  the  following  results? 1. It will degrade the performance  of  the  system 2. It will locate 95% of failures within  the  receiver– transmitter  only 3. It will locate 95% of failures within  the  receiver- transmitter  and  video processor to six possible modules 4. It will locate 95% of failures to  four  possible  modules within  the  receiver– transmitter  and  video processor 2-2. What  Navy  Enlisted  Classification code,    if any, applies to the AN/SPS–64(V)9  radar? 1. NEC ET–1507 2. NEC ET–1510 3. NEC ET–1524 4. None 2–3. Which  of  the  following information/support  is  available for  the  AN/SPS–64(V)9  technician? 1. 2M  Electronic  Repair  Program support 2. Formal  maintenance  training 3. Technical  Repair  Standards 4. Support  and  Test  Equipment Engineering  Program  (STEEP) 2–4. A radar video converter (RVC) modification  of  the  AN/SPS–55  was developed  for  which  class  of  ship? 1. DD–963 2. FFG–7 3. FFG–61 2–5. Which  of  the  following  missions  is NOT  supported  by  the  AN/SPS–55 radar? 1. ASW 2. AAN 3. SPW 4. MOB 2–6. The  AN/SPS–55  radar,  without  any modifications,    will  interface  with which  of  the  following  systems? 1. MK XII IFF 2. AN/SLA–10 3. AN/SYS–2(V)2 4. AN/SYS–1 2–7. An  operating  AN/SPS–55  radar  goes into standby mode and an indicator is activated at the RSC. What is the  probable  cause? 1. The  magnetron  has  exceeded safe  operating  parameters 2. The  modulator  has  exceeded safe  operating  parameters 3. A  low–voltage  condition  has occurred 4. The  high–voltage  power  supply has  exceeded  safe  operating parameters 2–8. What is the primary function of an AN/SPS–49(V)  radar? 1. Support of AAW 2. Backup to the weapon system designation  radar 3. Surface  search 4. Navigation 4. MCM-1 6