Tag-Out Information

Figure 1-13.—Instrument Log. transferred to this section of the log until they are reviewed and removed by the department head. TAG-OUT INFORMATION A tag-out procedure is necessary because of the complexity of modem ships and the cost, delays, and hazards to personnel that can result from the improper operation of equipment. Learn and use the following guidelines: 1. Enforce the tag-out procedure at all times. You must do this during normal operations as well as during construction, testing, repair, or maintenance. 2. Do not use tags or labels as a substitute for other safety measures. Examples are chaining or locking valves, removing fuses, or racking out circuit breakers. However, you must attach tags to the fuse panel, the racked-out circuit breaker cabinet, or a locked valve to show a need for action. You do not need to use tags where a device will be locked during normal operations. 3. Use tags to show the presence of, and the requirement for, freeze seals, blank flanges, or similar safety devices. When equipment or components are placed out of commission, use the tag-out procedures to control the status of the affected equipment. Examples are disconnecting electrical leads, providing jumpers, or pulling fuses for testing or maintenance. 4. Never use tag-outs to identify valves, to mark leaks, or for any purpose not specified in the tag-out procedure. 5. Do not laminate tags or labels for reuse. The reuse of tags or labels is not allowed. 1-14