|
| |
Back
B MIRROR SELF TEST FAILURE | Up
TM-11-6625-3081-23-5 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual | Next
CABLE ASSEMBLY (TARGET LAMP) 2A1A2A11W19 7 -9 INPUT CODE: DCDCTL |
TM 11-6625-3081-23
7-8. B MIRROR
7 -8
INPUT CODE:
DCBMIR (cont)
2. CORRECTIVE ACTION - DCBMIR (cont)
(f) Remove Cable Assembly 2A1A2A1W48.
Check contacts of mating connectors
and repair if required.
Install replacement 2A1A2A1W48 and perform
DCBMIR test.
If DCBMIR test passes, no further action required. If
DCBMIR test fails, proceed to (g).
(g) Remove Cable Assembly 2A1A2A1W49.
Check contacts of mating connectors
and repair if required.
Install replacement 2A1A2A1W49 and perform
DCBMIR test.
If DCBMIR test passes, no further action required. If
DCBMIR test fails, proceed to (h).
(h) Remove Cable Assembly 2A1A2A1W50.
Check contacts of mating connectors
and repair if required.
Install replacement 2A1A2A1W50 and perform
DCBMIR test.
If DCBMIR test passes, no further action required. If
DCBMIR test fails, proceed to (i).
(i) Check the following cable assemblies and repair as required:
W27
W28
W29
2A1W26
2A1W32
2A1A2W40
2A2W8
2A2W9
2A2W17
If any cable was repaired, perform DCAMIR test. If DCAMIR test passes,
no further action required.
If DCAMIR test fails and CALCST, PLLBUS,
MTRXSW, ADST, DIGITST, FPSST, and PPSST have been performed, repair is
beyond this level of maintenance.
Next higher level of maintenance
required.
If no cables were repaired and CALCST, PLLBUS, MTRXSW, ADST, DIGITST,
FPSST, and PPSST tests have been performed, repair is beyond this level
of maintenance.
Next higher level of maintenance required.
7-44
|
