|
| |
Back
INSTALLATION (cont) | Up
TM-11-6625-3081-23-4 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual | Next
INSTALLATION |
TM 11-6625-3081-23
5-6. BASE ASSEMBLY REPAIR (cont)
5-6
(19) Refer to 1 above and install
protective skirts.
(20) Refer to paragraph 5-7 and
adjust base assembly.
END OF TASK
b. To replace valve number 2,
proceed as follows:
REMOVAL
(1) Refer to 1 above and remove
front, rear, and right side
protective skirts.
(2) Refer to 2a above and
perform steps 2 thru 9.
(3) On isolator (1), tag and
disconnect yellow tube (2)
from tee fitting (3) and two
natural tubes (4) from oppo-
site tee fitting (5).
(4) Tag and disconnect yellow
tube (6) from isolator
fitting (7).
(5) Remove tubing clamps as
necessary.
(6) Remove four screws (8) and
valve assembly (9) from
isolator (1).
(7) Note location of tee fit-
tings (3 and 5) and remove
from valve (9). Clean
teflon tape residue from
threads.
(8) Remove two screws (10) and
valve cover assembly (11)
from valve (9).
5-34
|
