REMOVAL (cont)

TM 11-6625-3081-23 5-6. BASE ASSEMBLY REPAIR (cont) 5-6 A 10 inch x 10 inch x 0.25 inch plate must be used under each jack or van floor may be damaged. (5) Position a 10 inch x 10 inch x 0.25 inch plate (10) next to mounting plate (11) in floor. (6) Position jacks (12) under edge of base assembly (6). Be sure jacks are positioned over mounting plates (11) in floor and 10 inch x 10 inch x 0.25 inch plate (10). (7) position jack levers (13) UP and insert jack handles (14) into jacks (12). DO NOT PLACE HANDS OR FEET UNDER BASE WHILE USING JACK. INJURY COULD RESULT. Be sure jacks are raised at the same time to avoid damage to equipment. (8) Using an assistant, slowly raise base no higher than 4 inches with jacks. Operate jacks at same time. (9) Place hardwood blocks (15) under base, do not relieve weight of base from jacks (12). Remove jack handles from jacks. 5-23