|
| |
Back
INSTALLATION (cont) | Up
TM-11-6625-3081-23-4 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual | Next
REMOVAL |
TM 11-6625-3081-23
5-6.
BASE ASSEMBLY REPAIR (cont)
5-6
(16)
(17)
(18)
(19)
Position isolator (1) on
mounting plate.
Aline with
mark made during removal.
Install two bolts (9) and
lockwashers (10). Tighten
bolts until just seated on
isolator.
Be sure piston
end of isolator remains flat
on mounting plate.
Install laminated shims (13)
as required to fill gap
under isolator at valve
end.
Torque bolts (9) to
54 ft-lb.
CAUTION
Do not use wrench on tubing nuts.
Finger tighten only.
(20)
(21)
(22)
Refer to diagram below and
attach two natural tubes (4)
to tee fitting (5) and yel-
low tube (2) to opposite tee
fitting (3). Finger
tighten only.
Attach yellow tube (6) to
isolator fitting (7).
Finger tighten only.
Install piston plate (8) on
isolator (1)0
5-21
|
