|
| |
Back
REMOVAL | Up
TM-11-6625-3081-23-4 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual | Next
INSTALLATION (cont) |
TM 11-6625-3081-23
5-6. BASE ASSEMBLY REPAIR (cont)
5-6
(4) Remove piston plate (8) from
isolator (1).
(5) Remove tubing clamps as
necessary.
(6) Mark a line around bottom of
isolator (l). Replacement
isolator must be installed
in same position.
(7) Remove two bolts (9), lock-
washers (10), and isolator
(1).
(8) Remove four screws (11) and
valve assembly (12) from
isolator (1).
(9) Remove fitting (7) from
defective isolator and clean
teflon tape residue from
threads.
INSTALLATION
(10) Wrap teflon tape around
threads of fitting (7).
(11) Install fitting (7) into
replacement isolator (1).
5-19
|
