|
| |
Back
INSTALLATION (cont) | Up
TM-11-6625-3081-23-4 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual | Next
INSTALLATION (cont) |
TM 11-6625-3081-23
5-6. BASE ASSEMBLY REPAIR (cont)
5-6
CAUTION
Do not use wrench on tubing nuts.
Finger tighten only or leakage may
result.
(28)
(29)
(30)
(31)
(32)
Refer to diagram below and
attach two natural tubes
(20) to tee fitting (21) on
isolator (17).
Finger
tighten only.
Attach orange tube (18) to
tee fitting (19) on isolator
(17).
Finger tighten
only.
Attach orange tube (22) to
isolator fitting (23).
Finger tighten only.
Install piston plate (16) On
isolator (17).
Check that tubing is secured
by retaining clamps where
removed.
5-16
|
