|
| |
Back
BASE ASSEMBLY REPAIR | Up
TM-11-6625-3081-23-4 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual | Next
ISOLATOR ASSEMBLY REPLACEMENT |
TM 11-6625-3081-23
5-6. BASE ASSEMBLY REPAIR (cont)
5-6
REMOVAL
This procedure is used to remove
front, rear, or side protective
skirts from base.
a.
Refer to list below for
quantities of screws and
washers used in each skirt.
Skirt Quantity
Location of Screws
Front
9
Rear
10
Sides
8
NOTE
Front protective skirt is shown.
Rear and sides are similar.
b. Remove screws (1), washers
(2), retainer (3), and pro-
tective skirt (4).
INSTALLATION
c.
Install in reverse order of
removal.
END OF TASK
5-9
|
