|
| |
Back
CHAPTER 5 DIRECT SUPPORT MAINTENANCE INSTRUCTIONS ELECTRO-OPTICAL TEST BENCH SET | Up
TM-11-6625-3081-23-4 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual | Next
Section II. ELECTRO-OPTICAL TEST BENCH SET GENERAL MAINTENANCE INSTRUCTIONS |
TM 11-6625-3081-23
Section I.
REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND
DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
Subject
Para
Page
Common Tools and Equipment. . . . . . . . . . . . . . . . . . ...5-1
5-2
Special Tools, TMDE, and Support Equipment . . . . . . . . . . . . . 5-2
5-2
Repair Parts. . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-3
5-2
5-1. COMMON TOOLS AND EQUIPMENT
5-1
The maintenance tasks contained in this chapter use tools contained in Tool Kits,
Electronic Equipment TK-100/G and TK-105-G.
Other tools required are listed in
paragraph 5-2 and in the initial setup of the specific maintenance task.
5-2.
SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
5-2
For authorized special tools and support equipment pertaining to direct support
maintenance, refer to TM 11-6625-3081-23P, Repair Parts and Special TOOlS List
(RPSTL).
For some work on the Electro-Optical Test Bench Set, special tools, TMDE, or
support equipment are needed.
The following is a list of these items. Each item is
identified in the INITIAL SETUP of each maintenance task that requires it’s use.
Item
No.
National Stock No.
or
Part No.
Nomenclature
1
2
3
4
5
6
7
8
10
11
12
8415-00-082-6108
4240-00-052-3776 (GGG-531CL1)
6701300
4940-00-561-1002
2397418
NAS 1664
TE3A
TE1OO
2954T1O
N289B800
9
N79BO35-10
Apron, rubber
Goggles, acid-type safety
Gun, nitrogen gas
Gun, heat (500A)
Lift, chassis
Tool, contact installation/removal
Wrench, torque
Wrench, torque
Jack, duo lift ratchet
Wrench set, hex head ball end
Socket, 5/32 hex head ball end, 1/4” dr.
7/64” socket head key
5-3. REPAIR PARTS
5 - 3
Repair parts are listed and illustrated in the RPSTL (TM 11-6625-3081-23P)
covering organizational and direct support maintenance for this equipment.
5-2
|
