|
| |
Back
BLOWER ASSEMBLY 1A6 OR 1A12 REPAIR | Up
TM-11-6625-3081-23-4 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual | Next
BLOWER MOTOR REPLACEMENT |
TM 11-6625-3081-23
4-5.
BLOWER ASSEMBLY 1A6 0R 1A12 REPAIR (cont)
4-5
b.
Use shorting probe and short out
each capacitor terminal to
ground.
c.
Loosen nut (5).
d.
Rotate capacitor bracket (6),
loosen screw (7), and lift out
capacitor.
e.
Tag and remove three wires (8)
from capacitor terminals.
INSTALLATION
f.
Install capacitor in reverse
order of removal.
END OF TASK
BLOWER MOTOR REPLACEMENT
NOTE
This procedure is used to replace the
blower motor contained in blower
assembly 1A6 (1) or 1A12 (1).
REMOVAL
a.
Refer to paragraph 1 above and do
steps a and b.
b. Remove two retaining rings (4)
from each grill (5) and lift out
grill.
c.
On rear of blower assembly (1),
remove 11 screws (2) and eight
screws (3).
4-9
|
