|
| |
Back
Section II. ELECTRONIC STATION MAINTENANCE PROCEDURES | Up
TM-11-6625-3081-23-4 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual | Next
REMOVAL |
TM 11-6625-3081-23
4-4 .
AC CONTROL PANEL ASSEMBLY 1A5 REPAIR (cont)
4-4
b.
Locate defective circuit breaker.
Circuit
Applies
Breaker
Power To
CB1
Plug mold 1A1J2
CB2
Plug mold 1A1J1
CB3
Digital computer
assembly 1A1O
CB4
EO test bench
CB5
EO test bench
. —
— — .
c.
Remove nuts (2), washers (3), and
wire lugs (4) from both terminals
of defective circuit breaker.
d.
On front panel of AC CONTROL
panel assembly, remove two screws
(5) and remove defective circuit
breaker.
INSTALLATION
e.
Install replacement circuit
breaker in reverse order of
removal.
END OF TASK
TERMINAL BOARD TB1 REPLACEMENT
2.
REMOVAL
a.
On front panel of DC POWER SUPPLY
assembly (1), remove eight screws
(2), lockwashers (3), and Washer
(4), and pull out DC POWER SUPPLY
assembly.
4-4
Change 9
|
