|
| |
Back
CHAPTER 4 DIRECT SUPPORT MAINTENANCE INSTRUCTIONS ELECTRONIC STATION | Up
TM-11-6625-3081-23-4 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual | Next
Section II. ELECTRONIC STATION MAINTENANCE PROCEDURES |
TM 11-6625-3081-23
Section I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND
DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
Para
P a g e
Common Tools and Equipment. . . . . . . . . . . . . . . . . ..4-1
4-2
Special Tools, TMDE and Support Equipment . . . . . . . . . . . 4-2
4-2
Repair Parts. . . . . . . . . . . . . . . . . . . . . . . . ..4-3
4-2
4-1. COMMON TOOLS AND EQUIPMENT
4-1
The maintenance tasks described in this chapter use tools contained in Tool Kits,
Electronic Equipment TK-100/G and TK-105/G. Other tools required are listed in
paragraph 4-2 below and in the INITIAL SETUP of the specific maintenance task.
4-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
4-2
For authorized special tools and support equipment pertaining to direct support
maintenance, refer to TM 11-6625-3081-23P, Repair Parts and Special Tools List
(RPSTL).
For some work on the Electronic Station, special tools, TMDE, or support
equipment are needed. The following is a list of these items. Each item is
identified in the INITIAL SETUP of each maintenance task that requires its use.
National Stock No.
Item
or
No.
Part No.
Nomenclature
1
8415-00-082-6108
Apron, rubber
2
4240-00-052-3776 (GGG-531CL1) Goggles, acid-type safety
3
TBD
Probe, shorting
4
LN-24BP
1/8 inch hex head ball
end wrench
4-3. REPAIR PARTS
4-3
Repair parts are listed and illustrated in the RPSTL (TM 11-6625-3081-23P)
covering organizational and direct support maintenance for this equipment.
4-2
|
