|
| |
Back
Controller Power Supply | Up
TM-11-6625-3081-23-1 Electronic Equipment Test Facility TADS/PNVS Augmentation Equipment Manual | Next
CONTROLLER POWER SUPPLY ASSEMBLY |
TM 11-6625-3081-23
1-10. DESCRIPTION OF ELECTRONIC STATION (cont)
1-10
LED Placard
Function
PWR
5 vdc power and IEEE-488 operation good.
RDY
Ready indicates two status lines match user selection.
MTA
System operating in “mode talk”.
MLA
System operating in “mode listen”.
The power input is controlled by a POWER ON/off switch located on the front panel.
A computer/local operation switch is located beside the POWER ON/off switch. On the
rear panel are connections for the (A, B, and C) heat sources which are described in
the nightside test bench description.
The purpose of the temperature controller is
to control and monitor the heat source operation.
The temperature controller and
the heat sources make up a closed loop system.
Characteristics
Parameters
Operating Temperature:
65° thru 95°F
Differential Temperature (T Range):
14° thru 122°F
Spectral Output:
Graybody minimum emissivity > 0.98
Temperature Control
Dial Range:
0 to 99.99°c
Physical Dimensions:
Length 20.00 in
Width
19.00 in
Height
5.25 in
Weight 30 lb
Electrical Input:
115v + 11.5v -21.5v, 48 Hz thru 66 Hz
Change 9
1-14.1/(1-14.2 blank)
|
