Appendix B. COMPONENTS OF END ITEM LIST

TM 11-4940-480-14

APPENDIX B

COMPONENTS OF END ITEM LIST

Section I INTRODUCTION

the illustration on which the item is shown.

B-1. Scope

(2) Item number. The number used to identify

This appendix lists integral components of and basic

item called out in the illustration.

issue items for the AN/TSM-126A to help you inven-

b. National Stock Number. Indicates the National

tory items required for safe and efficient operation.

stock number assigned to the item and which will be us-

ed for requisitioning.

B-2. General

c. Part Number. Indicates the primary number used

This Components of End Item List is divided into the

by the manufacturer, which controls the design and

following sections:

characteristics of the item by means of its engineering

a. Section II. Integral Components of the End Item.

drawings, specifications, standards, and inspection re-

These items, when assembled, comprise the AN/

quirements to identify an item or range of items.

TSM-127A and must accompany it whenever it is trans-

Following the part number, the Federal Supply Code

ferred or turned in. The illustrations will help you iden-

for Manufacturers (FSCM) is shown in parentheses.

tify these items.

d. Description. Indicates the Federal item name and,

b. Section III. Basic Issue Items. These are the

if required, a minimum description to identify the item.

minimum essential items required to place the AN/

e. Location. The physical location of each item

TSM-126A in operation, to operate it, and to perform

listed is given in this column. The lists are designed to

emergency repairs. Although shipped separately packed

inventory all items in one area of the major item before

they must accompany the AN/TSM-126A during

moving on to an adjacent area.

operation and whenever it is transferred between ac-

f. Usable on Code. Not applicable.

countable officers. The illustrations will assist you with

g. Quantity Required (Qty Reqd). This column lists

hard-to-identify items. This manual is your authority to

the quantity of each item required for a complete major

requisition replacement BII, based on TOE/MTOE

item.

authorization of the end item.

h. Quantity. This column is left blank for use during

an inventory. Under the Rcvd column, list the quantity

B-3. Explanation of Columns

you actually receive on your major item. The Date col-

a. Illustration. This column is divided as follows:

umns are for your use when you inventory the major

item at a later date; such as for shipment to another site.

(1) Figure number. Indicates the figure number of

(Next printed page is B-3)

B-1/(B-2 blank)