Tool and Test Equipment Requirements

TM 11-6625-539-15-2

function.

maintenance function vary at different maintenance

categories, appropriate "worktime" figures will be

shown for each category. The number of task-hours

C-4. Tool and Test Equipment Requirements

specified by the "worktime" figure represents the

(Table 1)

average time required to restore an item (assembly,

a. Tool or Test Equipment Reference Code. The

subassembly, component, module, end item or

numbers in this column coincide with the numbers

system) to a serviceable condition under typical field

used in the tools and equipment column of the MAC.

operating conditions. This time includes preparation

The numbers indicate the applicable tool or test

time, troubleshooting time and quality assurance

equipment for the maintenance functions.

quality control time in addition to the time required

b. Maintenance Category. The codes in this column

to perform the specific tasks identified for the

indicate the maintenance category allocated the tool

maintenance functions authorized in the mainte-

or test equipment.

nance allocation chart. Subcolumns of column 4 are

c. Nomenclature. This column lists the noun name

as follows:

and nomenclature of the tools and test equipment

C - Operator/crew

required to perform the maintenance functions.

O - Organizational

F - Direct support

d. National/NATO Stock Number. This column

lists the National/NATO stock number of the specific

H - General support

D - Depot

tool or test equipment.

e. Column 5, Tools and Equipment. Column 5

e. Tool Number. This column lists the manufac-

turer's part number of the tool followed by the

specifies by code, those common tool sets (not

individual tools) and special tools, test, and support

Federal Supply Code for Manufacturers (5-digit) in

equipment required to perform the designated

parentheses.

Change 3

C-2