Chapter 8. GENERAL SUPPORT TESTING PROCEDURES

TM 11-6625-539-15-2

CHAPTER 8

GENERAL SUPPORT TESTING PROCEDURES

8-2. Test Equipment and Material

8-1. General

The only test equipment and material required for

a. Testing procedures are prepared for use by

testing the T.S-1836B/U is Voltmeter, Electronic

Electronic Field Maintenance Shops and Electronic

ME-30(*)/U and a 100-ohm, ±1 percent, ½-watt.

Service Organizations responsible for general sup-

resistor.

port maintenance of electronic equipment to deter-

mine the acceptability of repaired equipment. These

8-3. Modification Work Orders

procedures set forth specific requirements that re-

The performance standards listed in the teats (paras

paired equipment must meet before it is returned to

8-5 and 8-6) are based on the assumption that all

the using organization.

modification work orders have been performed. DA

b. Comply with the instructions preceding each

Pam 310-7 lists current MWO's.

chart before proceeding to the chart. Perform each

8-4. Physical Tests and Inspection

step in sequence. Do riot vary the Sequence. For each

step, perform all the actions required in the Control

a. Test Equipment and Materials. None required.

settings columns; then perform each specific test pro-

b. Test Connection and Conditions.

cedure, and verify it against its performance

(1) No connections are necessary.

standard.

(2) Remove the test set chassis from its case.

c. Procedure.

None--------------- Controls may be in

a. Inspect case and chassis for

a. No darnage evident or park

missing. External surfaces in-

any position.

damage, missing parts, and

tended to be painted do not

defective condition of paint.

show bare metal.

painting recommended In

of refinishing whenever

binding pints,

and

will not be

or polished

with

b. Inspect afl controls and mechan-

b. Screws, bolts, and nuta will be

ical assemblies for loose or

tight with none missing.

missing screws, bolts, and nuts.

c. No loosee parts or damage. No

c. Inspect all connectors, sockets,

missing parts.

receptacles, and fuseholders

and meter for looseness,

damage, or missing parts.

2 None---------------

a. Controls rotate. freely without

Controls may be in

a. Rotate all panel controls

binding or excessive looseness.

any position.

throughout their limits of travel.

b. Stops operate properly without

b. Inspect dial stops for damage or

evidence of damage.

bending; check for proper

operation.

c. Switches operate properly.

c. Operate switches-------------

MX-1292/PAQ

3 Connect mercury

Controls may be in

Turn on mercury vapor lamp and

All repaired or disturbed electrical

vapor lamp.

any position.

components and chassis surfaces

expose portion of equipment that

are covered. There must be no

haa been repaired or disturbed to

varnish on switch contacts or

direot rays of lamp.

moving parta of mechanical

assemblies.

8-1