Click here to make tpub.com your Home Page

Page Title: Chapter 6. TROUBLESHOOTING AND REPAIR
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Back
Figure 5-6. F.E.T. check, simplified schematic diagram.
Up
TM-11-6625-539-15-2 Test Set Transistor TS-1836 B/U Manual
Next
Troubleshooting Chart

TM 11-6625-539-15-2
TROUBLESHOOTING
AND
REPAIR
NOTE
6-1. Troubleshooting Techniques
Voltmeter, Electronic ME-30(*)/U repre-
a. General, The first procedure in servicing a
sents Voltmeter, Meter ME-30A/U and
defective test set is to sectionalize the fault.
Voltmeters, Electronic ME-30B/U, ME-
Sectionalization consists of tracing the fault to a
30/U, and ME-30E/U.
group of circuits concerned with one test function.
Once the defective function is found, isolation to the
defective part is accomplished. Troubleshooting is
performed by general support and depot repairmen.
b. Sectionalization. Listed in (1) and (2) below is a
group of tests that are arranged to help locate the
defect to a faulty component.
(1) Visual inspection. When the test set is
brought in for repair, remove the front panel and
inspect as follows:
(a) Check to see that all connections are properly
seated. Repair or replace any connections or leads
that are broken or otherwise defective.
(b) Check all switches and controls for ease of
operation.
(c) Remove the access cover to the batteries, and
check for corrosion and looseness of batteries.
(d) Inspect for loose or missing screws, specifi-
cally those that fasten the rear parts board in place.
(2) Operational tests. Operational tests fre-
quently indicate the general location of trouble. In
many instances, the test will determine the exact
nature of the fault. The operator's preventive
maintenance checks and operation check (para 4-4)
and the alignment procedures (para 7-1 through 7-4)
provide a good operational test.
(3) Troobleshooting chart and equipment re-
quired. The meter indications, or lack of meter
indications, and operational checks provide a sys-
tematic method of localizing trouble to the faulty
circuit. The trouble symptoms listed in the troub-
leshooting chart (para 6-2) provide additional infor-
mation for localizing troubles. The only test equip-
ment required is Voltmeter, Electronic ME-30(*)/U
(TM 11-6625-320-12).
Figure 6-1. Battery polarity and location, battery compartment.
Change 2 6 - 1

Privacy Statement - Press Release - Copyright Information. - Contact Us