Chapter 4. ORGANIZATIONAL MAINTENANCE

TM 11-6625-539-144

CHAPTER 4

ORGANIZATIONAL MAINTENANCE

Section I. ORGANIZATIONAL TOOLS AND EQUIPMENT

4-1. Special Tools and Test Equipment

42. Repair Parts

No special tools or test equipment are required for

Refer to TM 11-6625-539-24P for repair parts

organizational maintenance of the test set.

available for use at organizational maintenance.

REPAINTING AND REFINISHING INSTRUCTIONS

Section Il.

4-3, General

careful not to erase panel markings. No painting

is required on the back of the panel or anywhere

The case and cover of this equipment are con-

in the interior of the test set.

structed of molded plastic. The color is the same

throughout the full thickness of the parts. For

b. Refer to TB 74610 for instructions on the

this reason, no repainting of these parts is re-

care of painting equipment.

quired. Touchup painting should be done only on

those parts the original surface of which had been

45. Refinishing Exterior Surfaces

painted.

You may remove gouges or scratches in the plas-

tic case or cover with fine sandpaper. Sand only

4-4. Repainting Instructions

enough to remove rough edges. Do not disrupt the

surrounding finish any more than necessary. Do

a. Touch up the face of the front panel using

light spray enamel per spec MIL-E-1590B. Be

not attempt to fill scratches or gouges with paint.

Section Ill.

LUBRICATION INSTRUCTIONS

4-6. Lubrication Instructions

No lubrication is required for the test set.

Section IV. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES

47. General

ties together with corrective action as prescribed

in TM 38750.

To insure that the test set is always ready for

operation, inspect it systematically so that defects

may be discovered and corrected before they re-

48. Organizational Preventive Maintenance

suit in serious damage or failure. The necessary

Checks and Services

preventive maintenance checks and services are

Preventive maintenance checks and services ap-

listed and described in tables 3-1 and 4-1. The

plicable to organizational maintenance are listed

item numbers indicate the sequence of and the

in table 41.

minimum inspection required. Record all deficien-