Appendix C: ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST

TM 11-6625-539-14-3

APPENDIX C

ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT, AND

DEPOT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST

INTRODUCTION

Section i.

C-1. Scope

Code

Explanation

P--Repair parts which are stocked in or supplied from

This manual lists repair parts required for the

the GSA/DSA, or Army Supply system, and auth-

performance of general support and depot main-

orized for use at indicated maintenance categories.

tenance of the TS1836C/U. No parts are author-

P2--Repair parts which are procured and stocked for

insurance purposes because the combat or mili-

ized for organizational or direct support main-

tary essentiality of the end item dictates that a

tenance.

minimum quantity be available in the supply

NOTE

system.

No special tools, test, or support equip-

P9--Assigned to items which are NSA design controlled:

ment is required.

unique repair parts, special tools, test, measuring

and diagnostic equipment, which are stocked and

supplied by the Army COMSEC logistic system,

C-2. General

and which are not subject to the provisions of

This Repair Parts List is divided into the follow-

AR 380-41.

P10--Assigned to items which are NSA design controlled:

ing sections:

speciaI tools, test, measuring and diagnostic equip-

a. Repair Parts for Direct Support, General

ment for COMSEC support, which are account-

Support, and Depot Maintenance-Section II. A

able under the provisions of AR 38041, and which

list of repair parts authorized for the perform-

are stocked and supplied by the Army COMSEC

logistic system.

ance of maintenance at the general support and

M--Repair parts which are not procured or stocked, but

depot level.

are to be manufactured at indicated maintenance

levels,

b. Index-Federal Stock Number and Reference

A--Assemblies which are not procured or stocked as

N u m b e r Cross-Reference to Figure and Item

such, but are made up of two or more units. Such

Number or Reference Designation-Section III.

component units carry individual stock numbers

and descriptions, are procured and stocked separ-

A `list of Federal stock numbers in ascending nu-

ately and can be assembled to form the required

merical sequence, followed by a list of reference

assembly at indicated maintenance categories.

numbers in ascending alpha-numeric sequence,

X--Parts and assemblies which are not procured or

cross-referenced to the illustration figure number

stocked and the mortality of which normally is

and reference designation.

below that of the applicable end item or com-

ponent. The failure of such part or assembly

c. Index-Reference Designation Cross-Refer-

should result in retirement of the end item from

ence to Page Number--Section IV. A list of ref-

the supply system.

erence designations cross-referenced to page

Xl--Repair parts which are not procured or stocked.

numbers (not applicable).

The requirement for such items will be filled by

use of the next higher assembly or component.

X2--Repair parts which are not stocked. The indicated

C-3. Explanation of Columns

maintenance category requiring such repair parts

will attempt to obtain same through cannibali-

T'he folIowing provides an explanation of columns

zation. Where such repair parts are not obtain-

in the tabular lists:

able through cannibalization, requirements will be

requisitioned, with accompanying justification,

a. Source, Maintenance, and Recoverability

through normal supply channels.

Codes (SMR).

G--Major assemblies that are procured with PEMA

(1) Source code indicates the selection sta-

funds for initial issue only as exchange assem-

tus and source for the list item. Source codes are:

blies at DSU and GSU level. These assemblies

C-1