 |
|||
|
|
|||
|
Page Title:
Tool and Test Equipment Requirements |
|
||
| ||||||||||
|
|
  support equipment required to perform the
listed in column 2. When items are listed without
designated function.
maintenance functions, it is solely for purpose of
f. Column 6, Remarks. Column 6 contains an
having the group numbers in the MAC and
alphabetic code which leads to the remark in
RPSTL coincide.
section IV, Remarks, which is pertinent to the
d. Column 4, Maintenance Category. Column 4
item opposite the particular code.
specifies, by the listing of a "work time" figure in
the appropriate subcolumn(s), the lowest level of
C-4. Tool and Test Equipment Require-
maintenance authorized to perform the func-
ments (Sect. Ill)
tion listed in column 3. This figure represents
the active time required to perform that main-
a. Tool or Test Equipment Reference Code. The
tenance function at the indicated category of
numbers in this column coincide with the
maintenance. If the number or complexity of the
numbers used in the tools and equipment
tasks within the listed maintenance function
column of the MAC. The numbers indicate the
vary at different maintenance categories, ap-
applicable tool or test equipment for the main-
propraite "work time" figures will be shown for
tenance functions.
each category. The number of task-hours
b. Maintenance Category. The codes in this
specified by the "work time" figure represents
column indicate the maintenance category
the average time required to restore an item
allocated the tool or test equipment.
(assembly, subassembly, component, module,
c. Nomenclature. This column lists the noun
end item or system) to a serviceable condition
name and nomenclature of the tools and test
under typical field operating conditions. This
equipment required to perform the mainte-
time includes preparation time, troubleshooting
nance functions.
time, and quality assurance/quality control time
d. National/NATO Stock Number. This column
in addition to the time required to perform the
lists the National/NATO stock number of the
specific tasks identified for the maintenance
specific tool or test equipment.
functions authorized in the maintenance alloca-
e. Tool Number. This column lists the manu-
tion chart. Subcolumns of column 4 are as
facturer's part number of the tool followed by
follows:
the Federal Supply Code for manufacturers
C-Operator/Crew
(5-digit) in parentheses.
O-Organizational
C-5. Remarks (Sect. IV)
F-Direct Support
H-General Support
a. Reference Code. This code refers to the
D-Depot
appropriate item in section II, column 6.
e. Column 5, Tools and Equipment. Column 5
b. Remarks. This column provides the re-
specifies by, code, those common tool sets (not
quired explanatory information necessary to
individual tools) and special tools, test, and
clarify items appearing in section II.
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals