Section III. PREPARATION FOR MOVEMENT

TM 11-6625-444-14-2

Section III. PREPARATION FOR MOVEMENT

c. Grasp the voltmeter and transport it to the

3-14. General

desired location.

This section contains information regarding

movement of the voltmeter. Rack removal is

3-16. Rack Removal (Optional Rack Installation)

d e s c r i b e d first, followed by i n s t r u c t i o n s for

bench or shelf movement.

a. Set the POWER OFF/ON switch to OFF by

releasing it to the out position.

3-15. Bench/Shelf Movement

b. Disconnect any test leads or cables from

the front and rear panel terminals, if necessary.

a. Set the POWER OFF/ON switch to OFF by

releasing it to the out position.

c. Remove the voltmeter from the equipment

r a c k by removing the front mounting screws

b. Disconnect any test leads or cables from

from the brackets. (See figure 2-4.)

the front and rear panel terminals, if necessary.