Table 6-5. Active Filter (A10) Voltage Measurements

TM 11-6625-444-14-1

Table 6-5. Active Filter (A10) Voltage Measurements

Table 6-6. Buffer (A11) Voltage Measurements

+4.9

NOTE

All voltages measured with battery powered differential voltmeter (table 6-1).

6-4. Part Locations

6-3. Schematic Diagrams

Location of assemblies and troubleshooting test

A schematic diagram of each assembly in the

points are shown in figure 6-1. Calibration ad-

voltmeter is contained in figures FO-2 through

F O - 9 . An interconnect diagram and wiring

justment and test point locations are shown in

figure 6-2. Component part locations in each

diagram is shown in figures FO-10 and FO-11,

assembly are shown in figures 6-3 through 6-13.

respetively. All diagrams are located at the rear

of this manual