Section III. PREPARATION FOR MOVEMENT

TM 11-6625-444-14-1

Figure 3-4. Ratio overrange limits.

3-11. Standby Operation.

3-10. Printer Output Use

The voltmeter is completely solid-state in design

Data outputs representing logic status conditions

and construction. Consequently, no warmup

within the voltmeter are made available at J40 on

period or continuous operation is necessary.

the rear panel of the voltmeter. Pin numbers and

When measurements are not being made, the

signal functions at J40 are described in table 3-3.

voltmeter may be left on or off, as desired.

Monitoring of the signals is possible with a

printer, provided each signal line is isolated and

3-12. Procedures for Shutdown

guarded; otherwise, operation of the voltmeter

Turn off of the voltmeter can be done at any time

will be impaired due to loading effects of the

with inputs applied or disconnected. To turn off

printer. Required mating connector J40 is an

the voltmeter, set the POWER switch on the

MS3106R-36-10P. This connector is not supplied

front panel to OFF.

with the voltmeter.

Section Ill. PREPARATION FOR MOVEMENT

c. Remove the voltmeter from the equipment

3-13. General

rack by removing the mounting screws from the

This section contains information regarding

front panel (fig. 2-2).

movement of the voltmeter. Rack removal is

described first, followed by instructions for bench

3-15. Bench/ Shelf Movement

or shelf movement.

a. Set the POWER switch to OFF.

b. Disconnect test leads and cables from the

3-14. Rack Removal

voltmeter.

a. Set the POWER switch to OFF.

c. Grasp the voltmeter by the handles on the

b. Disconnect test leads and cables from the

front panel and carry it to the desired location.

front and rear panel, as applicable.