Section II. INSTALLATION INSTRUCTIONS

TM 11-6625-444-14-1

Figure 2-1. Packaging diagram

Section Il. INSTALLATION INSTRUCTIONS

2-3. Rack Installation

the rear panel to 115 (if line power is 115V AC) or

230 (if line power is 230V AC).

a. General. The voltmeter is designed for

(3) Connect line power cord to input power

installation in a standard 19-inch wide equipment

connector on rear panel and then plug it into the

rack. Attachment to the equipment rack is

nearest line power receptacle.

facilitated directly through holes in the front

CAUTION

panel of the voltmeter.

Insure that the round pin on the line

b. Procedure.

power cord is always connected to a high

(1) Position the voltmeter in the equipment

quality earth ground.

rack and attach in place in accordance with figure

(4) Make the appropriate connections at the

rear panel as shown in figure 2-3. The voltage

(2) Set the slide switch (16, fig. 3-2