Lowering Chassis

TM6625-316-35-14

Figure 14. Panel of Test Set, Electron Tube TV-2(*)/U, location of parts.

ing bolts on the bottom of each mounting bracket

20. Lowering Chassis

just behind the cutouts on the resistor mounting

If the part to be checked or replaced is located

b. Raise the tube tester to a vertical position

on the front of the tube tester chassis or mounted

so that it rests on the bottom edge of the panel

through the chassis, lower the chassis so that

and the chassis supports. Remove the mounting

the part can be reached without removing the

bolts nearer the top of the chassis on both

chassis from its mounting brackets; proceed as

chassis mounting brackets (figs. 17 and 19).

follows :

a. Place the panel of the tube tester face

Note. On the TV2A/U only, remove the flathead

downward (fig. 15). Remove the chassis mount-

bolt on the rear of the chassis (fig. 18).

AGO 1428A