Special Information

measure is expressed by a two-character alphabetical

MultimeterAN/USM-33.

abbreviation: e.g., ea. in, pr, etc., and is the basis used

to indicate quantities and allowances in subsequent

TM 11-6625-314-20P

Organizational Maintenance

columns. When the unit of measure differs from the unit

Repair Parts and Special

of issue, the lowest unit of issue that will satisfy the

Tools Lists: Multimeters

required units of measure will be requisitioned.

AN/USM-33 and AN/USM-

e. Quantity Incorporated in Unit. This column

33A.

indicates the quantity of the item used in the equipment.

30-Day DS/GS Maintenance Allowances.

1-5. Location of Repair Parts

a. This manual contains one cross-reference

NOTE

index (sec IV) to be used to locate a repair part when

Allowances in GS column are for GS

either the Federal stock number or reference number

maintenance only.

(manufacturer's part number) is known. The first column

(1) The repair parts indicated by asterisk

in the index is prepared in numerical or alphanumeric

entries in separate allowance columns for DS and GS

sequence in ascending order. The reference numbers

represent those authorized for use at that category of

(manufacturer's part numbers) are listed immediately

maintenance to be requisitioned on an "as required"

following the last listed Federal stock number in the

basis, until stockage is based on demand in accordance

index of Federal stock numbers.

with AR 710-2.

b. When the Federal stock number or

(2) Allowance quantities are indicated in

reference number is known, follow the procedures given

the special tool lists section. for special tools, TMDE,

in (1) and (2) below.

and other support equipment.

g. 1-Year

Allowances

Per

100

(1) Refer to the index of Federal stock

Equipments/Contingency Planning Purposes. Column

numbers (sec IV) and locate the Federal stock number

or reference number. The FSN and reference number

intentionally left blank.

are cross-referenced to the applicable figure and item

h. Depot Maintenance Allowance Per 100

number or reference designation.

Equipments. This column indicates opposite the first

(2) Refer to the repair parts list (sec II) and

appearance of each item the total quantity authorized for

locate the figure number (col 10a) and item number or

depot maintenance of 100 equipments.

reference designation (col 10b) as noted in the FSN

e. Illustration.

This column is divided as

index.

follows:

c. When the figure and item number or

(1) Figure number. Indicates the figure

reference designation are known. scrutinize columns

number of the illustration on which the item is shown in

10a and 10b of the repair parts list (sec II) until the item

TM 11-6625-314-15.

is located.

(2) Item number.

Indicates the item

d. When the FSN. reference number, figure

number or reference designation used to reference the

number, item number and reference designation are not

item in the illustration.

known, scrutinize column 3 of the repair parts list (sec II),

which is arranged in alphabetical order.

1-4. Special Information

a. Usable on codes are included in column 3.

1-6. Abbreviations

Uncoded items are applicable to all models.

Not applicable.

Identification of the usable on codes used in this

publication are -

1-7. Reporting of Equipment Publication

Code

Used on

AMD

AN/USM-33

Improvements

AME

AN/USM-33A

The

reporting

errors,

omissions,

and

b. The following publications pertain to the

recommendations for improving this publication by the

equipment and its components:

individual user is encouraged.

Reports should be

submitted on DA Form 2028 (Recommended Changes

TM 11-6625-314-15

Operator, Organizational,

to Publications) and forwarded direct to Commander,

Field, and Depot

US Army Electronics Command, ATTN: AMSELMA-

Maintenance Manual:

CRA, Fort Monmouth. N.J 07703.

(Next printed page is 6)