Figure 4-1. Lubrication Points

11-6625-2981-14

Figure 4-1. Lubrication Points

handle. Unscrew and take off three nuts and lock-

4-4. Lubrication.

washers 6. Lift out generator 7. Apply one drop of

Refer to figure 4-1. Crank handle 2 must be removed to

instrument oil to each end of drive shaft 8 and armature

provide access for lubrication. To unscrew the crank

shaft 9. Put the generator in place. Screw on and

handle from ratchet assembly 3, it is necessary to keep

tighten three nuts with lockwashers 6. Screw on crank

the ratchet assembly from turning. To lock the ratchet

handle 2. Replace the ohmmeter in the case. Screw in

assembly, position a blade screwdriver between post 4

the six screws holding the ohmmeter in the case.

and bearing support 5. Unscrew and take off the crank

4-2