Tool and Test Equipment Requirements (Table 1)

TM 11-6625-298-14

e. Column 5, Tools and Equipment. Column 5

specifies, by the listing of a "worktime" figure in

specifies by code, those common tool sets (not

the appropriate subcolumn(s), the lowest level of

individual tools) and special tools, test, and

maintenance authorized to perform the function

support equipment required to perform the

listed in column 3. This figure represents the

active time required to perform that maintenance

designated function.

function at the indicated category of maintenance.

C-4. Tool and Test Equipment Requirements

If the number or complexity of the tasks within

(Table 1)

the listed maintenance function vary at different

a. Tool or Test Equipment Reference Code. The

maintenance categories, appropriate "worktime"

numbers in this column coincide with the numbers

figures will be shown for each category. The

used in the tools and equipment column of the

number of task-hours specified by the "worktime"

MAC. The number indicate the applicable tool or

figure represents the average time required to

test equipment for the maintenance functions.

restore an item (assembly, subassembly, com-

b. Maintenance Category. The codes in this

ponent, module, end item or system) to a serv-

column indicate the maintenance category allocated

iceable condition under typical field operating

the tool or test equipment.

conditions. This time includes preparation time,

c. Nomenclature. This column lists the noun

troubleshooting time and quality assurance/quality

name and nomenclature of the tools and test

control time in addition to the time required to

equipment required to perform the maintenance

perform the specific tasks identified for the

functions.

maintenance functions authorized in the main-

d. National/NATO Stock Number. This column

tenance allocation chart. Subcolumns of column 4

lists the National/NATO stock number of the

are as follows:

specific tool or test equipment.

COperator/crew

e. Tool Number. This column lists the

OOrganizational

manufactures part number of the tool followed by

FDirect support

the Federal Supply Code for Manufacturers (5-

H-General support

digit) in parentheses.

DDepot

(Next printed page is C-3)

C-2