Figure 6-3. End shield and chassis assembly.

TM 11-6625-298-14

Figure 6-3. End shield and chassis assembly.

b. Removal of Chassis Cover.

(5) Inspect for loose or missing screws.

(6) Operate the unit according to the

(1) Remove the screw in the chassis directly

procedure paragraph 2-4b. This should provide

in front of the small recessed portion of the chassis

an indication as to any trouble which might be

NOTE

present.

d. Reassembly of Equipment.

Older models have a cover secured by four

small screws.

(1) Replace the chassis cover by pushing it

(2) Gently pry up the cover on one side. The

gently into place.

(2) Replace the screws on the chassis in front

cover will snap out of the chassis.

of the chassis cover.

c. Inspection. Make a preliminary inspection of

(3) Seat the gasket on the ridge on the inside

the equipment to determine the extent of repair

face of the end shield. If the gasket is damaged

necessary.

replace it with a new one.

(1) Inspect for broken insulation connections

(4) Grasp the crank handle and carefully

to terminals and other parts.

(2) Check for defective soldered connections.

insert the chassis into the case.

(5) Replace the four screws on the end shield

(3) Examine wiring to see that no bare wire is

and tighten them securely.

touching other wires or chassis.

(4) Test operation of the hand generator by

turning the crank; the shaft should move freely

and smoothly.