Click here to make tpub.com your Home Page

Page Title: Home Page

• OPERATOR'S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE OUTPUT METERS
• WARNING
• SAFETY STEPS
• Table of Contents
• Table of Contents-continued
• OUTPUT METERS TS-585A/U, TS-585C/U, AND TS-585D/U
• CHAPTER 1. INTRODUCTION
• ADMINISTRATIVE STORAGE.
• LIST OF ABBREVIATIONS.
• EQUIPMENT CAPABILITIES AND FEATURES.
• EQUIPMENT DATA.
• Section III PRINCIPLES OF OPERATION
• CHAPTER 2. OPERATING INSTRUCTIONS
• DESCRIPTION OF OUTPUT METER TS-585A/U.
• DESCRIPTION OF OUTPUT METER TS-585B/U, TS-585C/U, OR TS-585D/U.
• Section II OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES
• OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES
• OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES-continued
• OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES-continued
• Section III OPERATION UNDER USUAL CONDITIONS
• ASSEMBLY AND PREPARATION FOR USE.
• UNPACKING PROCEDURE.
• Schematic Drawing
• METER NEEDLE ZERO ADJUSTMENT FOR TS-585A/U.
• Schematic Drawing
• METER NEEDLE ZERO ADJUSTMENT FOR TS-585B/U, TS-585C/U, OR TS-585D/U.
• Schematic Drawing
• OPERATING PROCEDURES.
• MEASUREMENT-continued
• MEASUREMENT OF OUTPUT POWER USING TS-585B/U, TS-585C/U, OR TS-585D/U.
• MEASUREMENT-continued
• MEASUREMENT OF CHARACTERISTIC IMPEDANCE USING TS-585A/U-continued
• MEASUREMENT-continued
• MEASUREMENT OF CHARACTERISTIC IMPEDANCE USING TS-585B/U, TS-585C/U, OR TS-585D/U.
• MEASUREMENT-continued
• CHAPTER 3. OPERATOR MAINTENANCE
• SYMPTOM INDEX
• TROUBLESHOOTING
• TROUBLESHOOTING-continued
• Section III MAINTENANCE PROCEDURES
• CHAPTER 4. ORGANIZATIONAL MAINTENANCE
• Section II SERVICE UPON RECEIPT
• Section Ill PREVENTIVE MAINTENANCE CHECKS AND SERVICES
• ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES
• ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES-continued
• Section IV TROUBLESHOOTING
• SYMPTOM INDEX
• TROUBLESHOOTING
• Meter needle does not return to zero after equipment is turned off.
• Section V MAINTENANCE PROCEDURES
• TOUCHUP PAINTING.
• REPLACEMENT OF IMPEDANCE CONTROL KNOB ON OUTPUT METERS TS-585A/U, TS-585B/U, TS-585C/U and TS-585D/U.
• Schematic Drawing
• REPLACEMENT OF METER MULTIPLIER KNOB ON OUTPUT METER TS-585A/U, TS-585B/U, TS-585C/U and TS-585D/U.
• Schematic Drawing
• REPLACEMENT OF RUBBER BUMPERS ON OUTPUT METER TS-585A/U, TS-585B/U, TS-585C/U AND TS-565D/U.
• Schematic Drawing
• Section VI PREPARATION FOR STORAGE OR SHIPMENT
• Schematic Drawing
• CHAPTER 5. DIRECT SUPPORT MAINTENANCE
• CHAPTER 6. GENERAL SUPPORT MAINTENANCE
• Section II TROUBLESHOOTING
• SYMPTOM INDEX
• TROUBLESHOOTING-continued
• Meter indication too high at all positions of impedance control.
• Section III MAINTENANCE PROCEDURES
• OVERVIEW-continued
• REPLACEMENT OF CHASSIS.
• Schematic Drawing
• REPLACEMENT OF BINDING POST ASSEMBLY.
• Schematic Drawing
• MAINTENANCE OF CAPACITOR (TS-585A/U AND TS-585B/U ONLY).
• INSTALLATION
• MAINTENANCE OF VARIABLE RESISTOR.
• REMOVAL
• MAINTENANCE OF RADIAL RESISTOR.
• INSTALLATION
• MAINTENANCE OF THERMAL RESISTOR (TS-585D/U).
• INSTALLATION
• MAINTENANCE OF AXIAL RESISTOR.
• TEST
• REPLACEMENT OF METER MULTIPLIER TERMINAL BOARD.
• INSTALLATION-continued
• REPLACEMENT OF METER CALIBRATION TERMINAL BOARD.
• INSTALLATION
• TESTING OF METER.
• TESTING-continued
• REPLACEMENT OF METER.
• Schematic Drawing
• TESTING OF AUTOTRANSFORMER.
• TESTING-continued
• REPLACEMENT OF AUTOTRANSFORMER.
• Schematic Drawing
• CLEANING AND ADJUSTMENT OF IMPEDANCE NETWORK.
• ADJUSTMENT-continued
• TESTING OF IMPEDANCE NETWORK.
• TESTING
• TESTING OF METER MULTIPLIER CIRCUIT.
• TESTING-continued
• REPLACEMENT OF ROTARY SWITCH.
• INSTALLATION
• ALINEMENT OF METER CALIBRATION CIRCUIT (TS-585D/U ONLY).
• Schematic Drawing
• ALINEMENT-continued
• ALINEMENT-continued
• Section IV CALIBRATION
• CALIBRATION-continued
• Section V FINAL TESTING
• FINAL TESTING-continued
• TESTING OF METER MULTIPLIER CIRCUIT
• Schematic Drawing
• RESISTOR COLOR CODE MARKING (MIL-STD RESISTORS)
• WIRING DIAGRAM, OUTPUT METER TS-585B/U
• WIRING DIAGRAM, OUTPUT METER TS-585A/U
• WIRING DIAGRAM, OUTPUT METER TS-585C/U
• WIRING DIAGRAM, OUTPUT METER TS-585D/U
• SCHEMATIC DIAGRAM, OUTPUT METERS TS-585A/U AND TS-585B/U
• SCHEMATIC DIAGRAM, OUTPUT METER TS-585C/U
• SCHEMATIC DIAGRAM, OUTPUT METER TS-585D/U
• APPENDIX A. REFERENCES
• APPENDIX B. MAINTENANCE ALLOCATION
• EXPLANATION OF COLUMNS IN THE MAC, Section II.
• EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS, Section III.
• Section II MAINTENANCE ALLOCATION CHART FOR OUTPUT METER, AUDIO LEVEL, TS-585A, B, C, D/U
• Section Ill TOOL AND TEST EQUIPMENT REQUIREMENTS FOR OUTPUT METER, AUDIO LEVEL, TS-585A, B, C, D/U
• Section IV REMARKS
• APPENDIX A. COMPONENTS OF END ITEM AND BASIC ISSUE ITEMS LIST
• Section II COMPONENTS OF END ITEM LIST
• APPENDIX B. EXPENDABLE SUPPLIES AND MATERIALS LIST
• Section II EXPENDABLE SUPPLIES AND MATERIALS
• GLOSSARY
• GLOSSARY-continued
• INDEX
• INDEX-continued
• INDEX-continued
• INDEX-continued
• INDEX-continued
• THE METRIC SYSTEM AND EQUIVALENTS
• Blank Page
• Blank Page
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Blank Page
• TM-11-6625-291-14
• Blank Page
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Blank Page
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Blank Page
• Blank Page
• By Order of the Secretary of the Army
• Blank Page
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Blank Page
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Blank Page
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Blank Page
• Blank Page
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Blank Page
• Blank Page