 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
  *TB 9-4920-361-24
DEPARTMENT OF THE ARMY TECHNICAL BULLETIN
CALIBRATION PROCEDURE FOR
VERTICAL DISPLAY SYSTEM
LINE TEST SET, CANADIAN MARCONI,
MODEL 476-853 AND
VERTICAL DISPLAY SYSTEM BENCH TEST
SET, CANADIAN MARCONI, MODEL 476-854
Headquarters, Department of the Army, Washington, DC
18 July 2006
Distribution Statement A: Approved for public release; distribution is unlimited.
REPORTING OF ERRORS AND RECOMMENDING IMPROVEMENTS
You can improve this manual. If you find any mistakes or if you know of a way to
improve these procedures, please let us know. Mail your letter or DA Form 2028
(Recommended Changes to Publications and Blank Forms) directly to Commander,
US Army Aviation and Missile Command, ATTN: AMSAM-MMC-MA-NP, Redstone
Arsenal, AL 35898-5000. A reply will be furnished to you. You may also provide DA
Form 2028 information to AMCOM via e-mail, fax, or the World Wide Web. Our
FAX number is: DSN 788-6546 or Commercial 256-842-6546. Our e-mail address is:
2028@redstone.army.mil. Instructions for sending an electronic 2028 may be found
at the back of this manual.
For the World Wide Web, use:
https://amcom2028.redstone.army.mil.
Paragraph
Page
SECTION
Test instrument identification ............................
Forms, records, and reports.................................
Calibration description ........................................
EQUIPMENT REQUIREMENTS
Equipment required .............................................
Accessories required.............................................
Preliminary instructions......................................
Equipment setup ..................................................
Output voltages ....................................................
Torque No. 1 and No. 2 ........................................
Fuel quantity No. 1 and No. 2 .............................
Turbine gas temp No. 1 and No. 2 ......................
Engine oil temp No. 1 and No. 2 .........................
_________
*This bulletin supersedes TB 9-4920-361-35, dated 5 September 2003, including all changes.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals