LISTS OF ILLUSTATIONS

*TB 9-4910-556-35

DEPARTMENT OF THE ARMY TECHNICAL BULLETIN

CALIBRATION PROCEDURE FOR

STE-M1/FVS TEST SET

Headquarters, Department of the Army, Washington, DC

5 June 2003

Approved for public release; distribution is unlimited

REPORTING OF ERRORS AND RECOMMENDING IMPROVEMENTS

You can improve this manual. If you find any mistakes or if you know of a way to

improve these procedures, please let us know. Mail your letter, DA Form 2028

(Recommended Changes to Publications and Blank Forms), or DA Form 2028-2

directly to:

Commander, U.S. Army Aviation and Missile Command, ATTN:

AMSAM-MMC-MA-NP, Redstone Arsenal, AL 35898-5000. A reply will be furnished

to you. You may also provide DA Form 2028 information to AMCOM via e-mail, fax,

or the World Wide Web. Our fax number is DSN 788-6546 or Commercial 256-842-

6546. Our e-mail address is: 2028@redstone.army.mil. Instructions for sending an

electronic 2028 may be found at the back of this manual. For the World Wide Web,

use https://amcom2028.redstone.army.mil.

Paragraph

Page

SECTION

IDENTIFICATION AND DESCRIPTION

Test instrument identification ...........................

Forms, records, and reports ...............................

Calibration description ......................................

EQUIPMENT REQUIREMENTS

Equipment required ..........................................

Accessories required ..........................................

CALIBRATION PROCESS FOR VEHICLE TEST METER (VTM)

Preliminary instructions....................................

Equipment setup ...............................................

Dc voltage..........................................................

Resistance .........................................................

Dc current .........................................................

Ac current .........................................................

Ac voltage and frequency ...................................

Pressure............................................................

Vacuum .............................................................

RPM..................................................................

______________________

*This technical bulletin supersedes TB 9-4910-556-35, dated 22 January 1996, including all changes.

CHANGE 1