CALIBRATION PROCEDURE FOR SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE (STE/ICE-R)

DEPARTMENT OF THE ARMY TECHNICAL BULLETIN

CALIBRATION PROCEDURE FOR

SIMPLIFIED TEST EQUIPMENT FOR

INTERNAL COMBUSTION ENGINE

(STE/ICE-R)

Headquarters, Department of the Army, Washington, D. C.

29 March 2005

Distribution Statement A: Approved for public release; distribution is unlimited.

REPORTING OF ERRORS AND RECOMMENDING IMPROVEMENTS

You can improve this manual. If you find any mistakes or if you know of a way to improve

these procedures, please let us know. Mail your letter, DA Form 2028 (Recommended Changes

to Publications and Blank Forms), or DA Form 2028-2 directly to: Commander, U.S. Army

Aviation and Missile Command, ATTN: AMSAM-MMC-MA-NP, Redstone Arsenal, AL 35898-

5000. A reply will be furnished to you. You may also provide DA Form 2028 information to

AMCOM via e-mail, fax, or the World Wide Web. Our fax number is DSN 788-6546 or

Commercial 256-842-6546. Our e-mail address is: 2028@redstone.army.mil. Instructions for

sending an electronic 2028 may be found at the back of this manual. For the World Wide Web,

use https://amcom2028.redstone.army.mil.

Paragraph

Page

SECTION

IDENTIFICATION AND DESCRIPTION

Test instrument identification ................................

Forms, records, and reports.....................................

Calibration description ............................................

EQUIPMENT REQUIREMENTS

Equipment required .................................................

Accessories required.................................................

CALIBRATION PROCESSFOR VEHICLETEST METER(VTM)

Preliminary instructions..........................................

Equipment setup ......................................................

Dc voltage .................................................................

Resistance .................................................................

Dc current .................................................................

Frequency .................................................................

RPM ..........................................................................

Pressure ....................................................................

Vacuum .....................................................................

Final procedure ........................................................

_____________

*This technical bulletin supersedes TB 9-4910-555-35, dated 24 July 2003, including all changes.