Section I. GENERAL

TB 55-4920-329-35

Section I. GENERAL

Accuracy..........................................+ 3% full scale

1. Purpose and Scope. This bulletin provides

Tachometer range> .........................0-150 RPM

information for the periodic calibration of the Tester,

..........................................0-1500 RPM

Starter Torque, Go-Power Model GP-1500M, (type B-l).

Accuracy..........................................+ 2% full scale

It is to be used by personnel trained and qualified in the

use of calibration equipment.

c. Calibration

Time required ..................................3 hrs (approximate)

2. Report

Equipment

Publication

Technique........................................Physical and Low

Improvements.

Reports of errors, omissions and

..........................................Frequency

recommendations for improving this publication by the

4. General Instructions

user is encouraged. Reports should be submitted on DA

a. DA Form 2416 (Calibration Data Card). During

Form 2028 (Recommended Changes to DA publications)

the performance of this procedure annotate DA Form

and forwarded direct to Commanding General, U. S.

2416 in accordance with TM 38-750. Annotate only the

Army Aviation Systems Command, ATTN: AMSAV-R-

parameters with the annotation note in performance

EGC, P. O. Box 209, St. Louis, Missouri 63166.

checks.

3. Descriptive Data.

b. Unit Under Test. Tester, Starter Torque, Go-

Power Model GP-1500M, figure 1, will be referred to as

a. Identification

the UUT (unit under test).

Nomenclature ................................ TESTER, STARTER

.... ................................................. TORQUE

Manufacturer ................................. Go -Power Corp.

c. Equipment and Accessory Identification. The

Manufacturer's Model Number ...... GP-1500M (Type B-l)

equipment and accessories referred to throughout this

FSN ............................................... 4920-933-7346

bulletin are identified in Tables 1 and 2 and Section III.

Reference ........................................... Manufacturer's manual

d. Equipment Setup. Disconnect instructions are

b. Specifications

not contained in this bulletin.

Torque range ...................................... 0-200 ft-lb

............................................. 0-600 ft-lb

5. Differences Among Models. None.

............................................. 0-1500 ft-lb

Figure 1. Tester, starter torque