Table 5. Rf Circuit Values

Table 5. Rf Circuit Values

Adjust each potentiometer for best results at each

group of settings.

(2) If R7708 or R7611 is adjusted, recheck

previous switch positions in that group until all in-

dications are within the prescribed tolerances. (R)

13. Final Procedure.

a. Deenergize and disconnect all test equipment,

and install unit under test in protective cover.

b. In accordance with TM 38-750, annotate and

affix calibration DA label 80 (U.S. Army Calibra-

*Use calibrated rf output of Signal Generator AN/URM-25( ) ter-

tion System), When the unit under test cannot be

minated into 50 ohms.

adjusted to within tolerance, annotate and affix DA

b. Adjustments.

f o r m 2417 (Unserviceable or Limited Use

Tag).

(1) Make adjustments as listed in table 5.