Section III. CALIBRATION PROCESS

Table 3 Accessories Required - Continued

*Six required. Must be furnished with item (A4) at time of calibration.

Section III. CALIBRATION PROCESS

6. Preliminary Instructions. a. The instructions

of each test and, whenever the test require-

outlined in paragraphs 6 and 7 are preparatory to the

ment is not met, take corrective action before

calibration process. Personnel should become familiar

continuing with the calibration. Additional

with the entire bulletin before beginning the calibra-

maintenance information is contained in the

tion.

manufacturer's manual for this TI.

b. Items of equipment used in this procedure are

NOTE

referenced within the text by common name and item

When indications specified in paragraphs 8

identification number as listed in tables 2 and 3. For

and 11 are not within tolerance, perform the

the identification of equipment referenced by item

power supply check prior to making adjust-

numbers prefixed with A, see table 2, and for prefix B,

ments. After adjustments are made, repeat

paragraphs 8 and 11. Do not perform power

WARNING

supply check if all other parameters are with-

HIGH VOLTAGE is used during the perfor-

in tolerance.

NOTE

mance of this calibration. DEATH ON CON-

TACT may result if personnel to observe

Unless otherwise specified, all controls and

safety precautions.

control settings refer to the TI.

NOTE

7. Equipment Setup. a Connect equipment as shown

Unless otherwise specified, verify the results