Final Procedure

b. Adjustments.

volts, dc supply located on top center of main

assembly.) (4) No further adjustments can be made.

(1) Remove screws securing main assembly

to protective case.

8. Final Procedure. a. Deenergize unit under test

disconnect dc voltmeter, and reinstall main assembly in

protective case.

(2) Carefully remove unit under test from

protective case.

b. In accordance with TM 38-750, annotate and

affix calibration DA Label 80 (U.S. Army Calibration

(3) Rotate voltage adjust potentiometers

System). When the unit under test cannot be adjusted

(located on power supply circuit cards) on power

to within tolerance, annotate and affix DA Form 2417

supplies to obtain indications on dc voltmeter within the

(Unserviceable Limited Use).

limits specified in table 2. (+18 volts, dc supply located

on bottom, rear of main assembly and -18